![\"\"](\"http:\/\/www.apolonio.com\/blog\/wp-content\/uploads\/2018\/03\/433MhzRelay.jpg\")
<\/a><\/p>\nVery little documentation on hot configure this, but I was able to work it out.<\/p>\n
Here it is<\/p>\n
Before starting, the unit should be powered by a 12 volt DC Power Supply<\/p>\n
Clearing the Module<\/h1>\n
After the unit is powered on, you should first clear the codes that were on the unit.<\/p>\n
- \n
- Click the button on the unit 8 times,<\/li>\n
- The flashing should indicate the codes unit has been cleared.<\/li>\n<\/ol>\n
Non Latched Mode<\/h1>\n
Some also call this Jog Mode.\u00a0 In this mode while you have the button pressed on the remote the relay will switch<\/p>\n
- \n
- Press the unit 1 time<\/li>\n
- Wait till the LED lights up<\/li>\n
- While the LED lights up send the code from your remote<\/li>\n<\/ol>\n
Self Latched Mode<\/h1>\n
Some call this self locked mode.\u00a0 In this mode a press of the button switches the relay, another press of the same button reverses the switch of the relay.<\/p>\n
- \n
- Press the unit 2 times<\/li>\n
- Wait till the LED lights up<\/li>\n
- While the LED lights up send the code from your remote<\/li>\n<\/ol>\n
Latched Mode<\/h1>\n
Some call this interlocked mode.\u00a0 In this mode you will need to send two different codes, one code switches the relay, and the other code reverses the relay.<\/p>\n
- \n
- Press the unit 3 times<\/li>\n
- Wait till the LED lights up<\/li>\n
- Send the first code from your device, it will flash that it code the code<\/li>\n
- Wait will the LED lights up solid<\/li>\n
- Send the second code from your device.<\/li>\n<\/ol>\n
<\/p>\n","protected":false},"excerpt":{"rendered":"
Today I got a bunch of packages, one of them contained some relatively cheap 433Mhz Relay modules. Very little documentation on hot configure this, but I was able to work it out. Here it is Before starting, the unit should … Continue reading