Category Archives: Training

This is all items related to my physical training.

433Mhz wemos gateway

Here is a picture of how the wiring goes Here it is with some of the components Looks good, really simple build.  Those red and two black wires on the right are not needed. Tomorrow will have some code.  

Posted in Training | 1 Comment

Not Enough Sleep

Got to sleep in today but was so tired still. Not sure if it is the culmination of a brutal September, but I did feel like a needed a nice long sleep. Tonight I will go to bed late, partially … Continue reading →

Posted in Training | Leave a comment

Sore Shoulder

Pain starting to creep all over, I think it is time to check it out. Going to try and hang in there for a bit then call it in. Can’t do a lot of things and it is getting worse … Continue reading →

Posted in Training | Leave a comment

Feels Like A Weekend

Week feels like it is a weekend. Kind of slow day, but I got some much work to do. Maybe progress is slow that is why I feel so busy. Tired though.

Posted in Training | Leave a comment

433Mhz Gateway ESP8266

I am thinking of putting together these instructions on how to build these things. Little note though, the one pictured above is for 315Mhz, 433Mhz ones are on the way. Hopefully will have a how to on these in the … Continue reading →

Posted in Technical, Training | Leave a comment

Slept Early Still Tired

Went to bed early yesterday, but woke up and had a busy day at work. It drained me bad. Still busy, still a lot of work.  Hope I can make things work out. Tonight I will sleep early again.

Posted in Training | Leave a comment

Looking At Good Sleep

Will try to get some deep sleep tonight. Been taking ambien the past few nights.  Time to go off it again. Am beat though. Should sleep well.

Posted in Training | Leave a comment

OpenVPN Presentation

Got to put together a presentation on openvpn tomorrow. Really really tired. Going to wake up early tomorrow and deal with it then.

Posted in Training | Leave a comment

Sliding Door Level

A carpenter came in and got our door settled. It is good now.  Going to move forward and finish the outside. Looking good, need this stress point off me.

Posted in Training | Leave a comment

External 433Mhz Sensor

Trying to get an outdoor 433Mhz sensor working outside. Seems to not work, I am suspect there is just too much interference between the outside transmitter and the receiver. There are a few things I would like to try, but … Continue reading →

Posted in Technical, Training | Leave a comment